Ponownie regulacja menzury i akcji

4 komentarze

1. Usuwać nie trzeba, ale można zamknąć.

2. Tak, tak, problem jest taki, że ten mostek działa w moim odczuciu zupełnie
   inaczej niż ten opisywany w tym kursie.

   PS. Trzeba koniecznie luzować struny do tych operacji?

3. 3 minuty zajęło mi znalezienie odpowiedzi.

   @Spector manual:
   The Spector Bridge
   How To Adjust It:
   The Spector Locking Bridge is found on all basses with the exception of the
   Performance Series. The design consideration is that while this bridge is
   sophisticated, it is actually very simple and EASY to adjust. Another profound
   benefit of the Spector Locking Bridge is that it LOCKS. You cannot adjust it, until
   you unlock it. Once adjusted, lock it and it will STAY where you put it. To adjust,
   leave the strings on the bass and tuned to normal pitch. Loosen the set screw on
   side of bridge with Allen wrench. Using same Allen wrench as above, adjust height
   of each string saddle as needed to suit your playing style. Adjust the intonation of
   each bridge saddle by moving the saddle away from the neck (if the higher
   register notes are playing sharp) or toward neck (if the higher notes are playing
   flat) as needed. For optimum performance, each of the saddles should be tilted
   back toward the ball end of the string at the same angle as the headstock tilt (but
   opposite in direction). Tighten set screw on side of bridge and now the saddles will
   stay in place even when strings are changed. This solid contact also adds to the
   overall sustain and tone of the Spector Bass.

   Luzujesz struny. Luzujesz śruby po bokach. Przestawiasz kowadełka. Dokręcasz
   śruby. Stroisz i sprawdzasz czy jest dobrze ustawiona menzura.

   Jak nie jest to powtarzasz proces.

   edit: co za cieć zamyka temat? Nie skończyliśmy tematu więc WĄ! Koledzy
   moderatorzy! Co z wami?!

4. McGregor – dzięki

Możliwość komentowania została wyłączona.